Instruction for Kimat Lift

INSTRUCTION FOR KIMAT LIFT

Park the car on a level ground. Take the KL (Kimat Lift) out. Remove the cover. Unwind the straps. Extend or join the shorter bars into a longer one.
Open the PS (Passenger Side) door. Put the KL across the seats. Lift the bar up to the assist strap by holding up the top ratchet and hang the bar to the strap. Throw the doubled strap over the roof to DS (Driver Side).
Go to the DS and open the door. Lift the bar up and put on the strap around the overhang. Go back to PS and tighten the strap. Hold the bar up against the roof.
Park the wheelchair along the PS of the vehicle. Hook and lift the patient up. Move the wheelchair out of way. Slide the patient into the car over the seat. Lower and secure the patient. Unhook and slide back the lift ratchet.
Loosen the top strap. Go to DS. Separate the strap from the bar. Lower the bar. Go to PS. Remove the KL from the assist strap. Shorten, pack, and store the KL.

To transfer the patient to the wheelchair, repeat the steps. Except, reverse 4.

How to put a LIAPER on

Slip the strap around the waist either up from the legs or down over the head.
Rotate the fabric to the back. Pull up the small loop between the legs.
Pass the middle of the other strap thru the loop to make a new hanging loop.
Repeat 3 to shorten the hanging loop or to prevent over-tightening the waist.
Pin the hanging loop on the shirt or jersey when it is not suspended.

Note: New waist strap has an adjusting buckle. The hanging loop should come to tommy.
Kimat Lift and Liaper are products of Kimat Lab. Made in the USA and Patents are pending.